DataSheet.in

LC587508A डेटा पत्रक PDF( Datasheet डाउनलोड )


डेटा पत्रक - (LC587504A - LC587508A) 4-Bit 1-Chip Microcomputers - Sanyo

भाग संख्या LC587508A
समारोह (LC587504A - LC587508A) 4-Bit 1-Chip Microcomputers
मैन्युफैक्चरर्स Sanyo 
लोगो Sanyo लोगो 
पूर्व दर्शन
1 Page
		
<?=LC587508A?> डेटा पत्रक पीडीएफ

LC587508A pdf
www.DataSheet4U.com
LC587508A, 587506A, 587504A
Instruction Cycle Time
(all instructions except table lookup instructions execute in one cycle)
LCD voltage step-up option (1.5V power supply/Ag battery, etc.)
Cycle Time
20µs
122µs
Supply Voltage
1.35 to 1.75V
1.35 to 1.75V
System Clock Oscillation Source
RC oscillator
Xtal (crystal) oscillator
Oscillation Frequency
200kHz
32.768kHz
LCD voltage step-down option (3.0V power supply/Li battery, etc.)
Cycle Time
Supply Voltage
System Clock Oscillation Source
Oscillation Frequency
1µs 4.5 to 5.5V CF (ceramic) oscillator
4MHz
4µs 2.5 to 5.5V CF (ceramic) oscillator
1MHz
10µs
2.5 to 5.5V
CF (ceramic) oscillator
400kHz
122µs
2.0 to 5.5V
Xtal (crystal) oscillator
32.768kHz
* It must be noted when using an LCD, that the lower limit of the system operating voltage becomes
higher in accordance with the LCD's bias specifications.
Ports
Input-only pins
Port S (4 pins)
INT pin (1 pin)
Input/output pins
Port K (4 pins)
The output type is fixed to "CMOS".
Port M (4 pins)
The output type can be programmed to "CMOS" or "Pch" on a port basis.
(The M4 pin is configured as a signal input pin when timer 2 is set in the event counter mode).
Port SO (4 pins)
The output type can be programmed to "CMOS" or "Nch" on a port basis. The three pins SO1, SO2, and SO3
are also used for the serial interface (2-pin serial communication is also possible).
Port P (4 pins)
The output type can be programmed to "CMOS" or "Pch" on a port basis.
Port A (4 pins)
The output type can be programmed to "CMOS" or "Pch" on a port basis.
Output-only pins
Port N (4 pins)
The N3 pin is also used as the remote controller carrier output pin. The N4 pin is also used as the alarm output
pin.
LCD driver pins
Common pin (4 pins)
Segment pin (35 pins)
Each segment pin incorporates dedicated memory (segment memory) for holding output data. Its output type can
be changed under program control from "LCD driver output" to a general-purpose output type (CMOS, Pch, or
Nch).
Variety of LCD Drive Modes
LCD Drive Mode
1/3 bias, 1/4 duty
1/3 bias, 1/3 duty
1/2 bias, 1/4 duty
1/2 bias, 1/3 duty
DUPLEX
STATIC
No. of Drivable Segments
140 segments
105 segments
140 segments
105 segments
70 segments
35 segments
Required Common Pins
COM1 to COM4
COM1 to COM3
COM1 to COM4
COM1 to COM3
COM1 and COM2
COM1
No.7807-2/17

विन्यास 18 पेज
डाउनलोड[ LC587508A Datasheet.PDF ]


शेयर लिंक


अनुशंसा डेटापत्रक

भाग संख्याविवरणविनिर्माण
LC587508A(LC587504A - LC587508A) 4-Bit 1-Chip MicrocomputersSanyo
Sanyo


भाग संख्याविवरणविनिर्माण
30L120CTSchottky RectifierPFC Device
PFC Device
AT28C010-12DKSpace 1-MBit (128K x 8) Paged Parallel EEPROMATMEL
ATMEL
B20NM50FDN-CHANNEL POWER MOSFETSTMicroelectronics
STMicroelectronics
D8442SD844SavantIC
SavantIC
FAE391-A20AM/FM Automotive Electronic TunerMitsumi
Mitsumi


Index : 0  1  2  3  4  5  6  7  8  9  A  B  C  D  E  F  G  H  I  J  K  L  M  N  O  P  Q  R  S  T  U  V  W  X  Y  Z



www.DataSheet.in    |   2017   |  संपर्क   |   खोज     |   English