DataSheet.in

AT24RF08C डेटा पत्रक PDF( Datasheet डाउनलोड )


डेटा पत्रक - 1K x 8 Dual Access EEPROM - ATMEL Corporation

भाग संख्या AT24RF08C
समारोह 1K x 8 Dual Access EEPROM
मैन्युफैक्चरर्स ATMEL Corporation 
लोगो ATMEL Corporation लोगो 
पूर्व दर्शन
1 Page
		
<?=AT24RF08C?> डेटा पत्रक पीडीएफ

AT24RF08C pdf
General Overview
The AT24RF08C is intended to be pin compatible with
standard serial EEPROM devices except for pins 1, 2 and
3, which are address pins in the standard part. Other
exceptions to the AT24C08 Serial EEPROM data sheet are
noted in the Serial EEPROM Exceptionssection later in
this document. Connection of an external coil antenna and
optional tuning capacitor, normally via a two conductor
wire, is all that is required to complete the RFID hardware
requirements.
Throughout this document, the term readeris defined as
the base station that communicates with the chip. Under all
expected conditions, it actually serves as both a reader and
writer. The term tagis used to indicate the chip when
operating as an RFID transponder with the coil attached.
All bits are sent to or read from the device, most significant
bit first, in a manner consistent with the AT24C08 Serial
EEPROM. The bit fields in this document are
correspondingly listed with the MSB on the left and the LSB
on the right.
EEPROM Organization
The EEPROM memory is broken up into 8 blocks of 1K
bits (128 bytes) each. Within each block, the memory is
physically organized into 8 pages of 128 bits (16 bytes)
each. In some instances, accesses take place on a 32-bit
(4 byte) word basis. In addition to these 8K bits, there are
two more 128-bit pages that are used to store the access
protection and ID information. There are a total of 8448 bits
of EEPROM memory available on the AT24RF08C.
Access protection (both read and write) is organized on a
block basis for blocks 1 through 7 and on a page and block
basis for block 0. Protection information for these blocks
and pages is stored in one of the additional pages of
EEPROM memory that is addressed separately from the
main data storage array. See Access Protectionon page
3 for more details.
The ID value (see ID Configurationon page 7) is located
in the ID page of the EEPROM, the second of the additional
16 byte pages.
Writes from the serial port may include from one to 16
bytes at a time, depending on the protocol followed by the
bus master. Accesses to the EEPROM from the RFID port
are on either a word (32 bits) or page (128 bits) basis only.
All page accesses must be properly aligned to the internal
EEPROM page.
The EEPROM memory offers an endurance of 100,000
write cycles per byte, with 10 year data retention. Writes to
the EEPROM and tamper bit take less than 10 ms to
complete.
Completion time for writes initiated from the RFID port are
different depending on the situation. When external power
is supplied to the chip through the VCC pin, writes to the
EEPROM and tamper bit take less than 11.8 ms when
measured from the last modulation edge before the write to
the first after the write. When powered from the coil pins at
125 KHz, the EEPROM write time will be 5.8 ms and the
tamper write time will be 7.9 ms.
After manufacturing, all EEPROM bits except in the device
revision byte (see Access Protectionpage 5) will be set to
a value of 1 and the tamper bit will be set to 0.
Device Access
The third device address bit in the two wire protocol that is
usually matched to A2 (pin 3) on a standard AT24C08 serial
EEPROM is internally connected high, so device
addresses A8 through AF (hex) are used to access the
memory on the chip. The general command encoding used
by the serial port for EEPROM accesses is shown below in
Device Access Examples, where B2-0 is the block number,
P2-0 is the page number within the block and A3-0 is the byte
address within the page. Bits denoted as xare ignored by
the device.
The PROT pin is used as a power good signal. When this
pin is low, the serial port is held in reset and all sticky bits
are set to one. When high, activity on the serial bus is
permitted.
Device Access Examples
For Write Operations:
1 0 1 0 1 B2 B1 0
B0 P2 P1 P0 A3 A2 A1 A0
D7 D6 D5 D4 D3 D2 D1 D0
For Read Operations:
10101XX1
D7 D6 D5 D4 D3 D2 D1 D0
2 AT24RF08C

विन्यास 21 पेज
डाउनलोड[ AT24RF08C Datasheet.PDF ]


शेयर लिंक


अनुशंसा डेटापत्रक

भाग संख्याविवरणविनिर्माण
AT24RF081K x 8 Dual Access EEPROM with RFID and Serial InterfacesATMEL Corporation
ATMEL Corporation
AT24RF08C1K x 8 Dual Access EEPROMATMEL Corporation
ATMEL Corporation


भाग संख्याविवरणविनिर्माण
30L120CTSchottky RectifierPFC Device
PFC Device
AT28C010-12DKSpace 1-MBit (128K x 8) Paged Parallel EEPROMATMEL
ATMEL
B20NM50FDN-CHANNEL POWER MOSFETSTMicroelectronics
STMicroelectronics
D8442SD844SavantIC
SavantIC
FAE391-A20AM/FM Automotive Electronic TunerMitsumi
Mitsumi


Index : 0  1  2  3  4  5  6  7  8  9  A  B  C  D  E  F  G  H  I  J  K  L  M  N  O  P  Q  R  S  T  U  V  W  X  Y  Z



www.DataSheet.in    |   2017   |  संपर्क   |   खोज     |   English