DataSheet.in

LC573015A डेटा पत्रक PDF( Datasheet डाउनलोड )


डेटा पत्रक - 4-bit Single Chip Microcontroller - Sanyo

भाग संख्या LC573015A
समारोह 4-bit Single Chip Microcontroller
मैन्युफैक्चरर्स Sanyo 
लोगो Sanyo लोगो 
पूर्व दर्शन
1 Page
		
<?=LC573015A?> डेटा पत्रक पीडीएफ

LC573015A pdf
LC573010A, 573015A
• Port
– Input port (S port, M port) : 2-port (8 pins) [Key scan input port]
– Input/Output port
: 3-port (10 pins)
P0 port, P1 port
2-port (8 pins) [Key scan output port]
P2 port
1-port (2 pins) [Key scan expansion port]
[LED direct drivable port]
• Infrared remote control carrier generation circuit
– Software-controllable remote control carrier output ON/OFF.
– Software-controllable carrier frequency and duty ratio.
<38 kHz-1/3 duty, 38 kHz-1/2 duty, 57 kHz-1/2 duty>
(When fixed carrier signal is output, it is specified by mask option)
– 1 kHz to 200 kHz infrared remote control transmission carrier frequency.
(When carrier output is selected by timer at mask option, and when 455 kHz CR oscillator is used)
– Infrared carrier output-dedicated terminal built-in (CA terminal).
– 108 ms HALT-mode cancel signal output.
• Timer
– 16-bit software-controllable timer
Timer input clock : Ceramic (CR) oscillation frequency (455 kHz)
– 108 ms HALT release request signal generation timer (Free running timer)
– Watchdog timer (changed over between USED/UNUSED by mask option)
• Sub-routine stack level
– 2 levels
• Oscillation circuit
– Ceramic (CR) oscillation circuit : 455 kHz (for System clock generation), feedback resistor built-in.
• Standby function
– HALT mode
HALT mode used to reduce current drain.
HALT mode suspends program execution.
Following shows how to release the HALT mode.
(A) System reset
(B) HALT mode release request signal
– HOLD mode
HOLD mode stops ceramic resonator (CR). The HOLD mode can be released in two ways.
(A) System reset
(B) Apply H level input to S port pin or M port pin. (However, it is necessary to set S port or M port HOLD mode
release permission flag beforehand.)
• Form of shipment
– MFP-24S (1.0 mm pitch)
Note : When dipping in solder to mount the MFP package on board, contact SANYO for instructions.
No. 5899-2/12

विन्यास 12 पेज
डाउनलोड[ LC573015A Datasheet.PDF ]


शेयर लिंक


अनुशंसा डेटापत्रक

भाग संख्याविवरणविनिर्माण
LC573015A4-bit Single Chip MicrocontrollerSanyo
Sanyo


भाग संख्याविवरणविनिर्माण
30L120CTSchottky RectifierPFC Device
PFC Device
AT28C010-12DKSpace 1-MBit (128K x 8) Paged Parallel EEPROMATMEL
ATMEL
B20NM50FDN-CHANNEL POWER MOSFETSTMicroelectronics
STMicroelectronics
D8442SD844SavantIC
SavantIC
FAE391-A20AM/FM Automotive Electronic TunerMitsumi
Mitsumi


Index : 0  1  2  3  4  5  6  7  8  9  A  B  C  D  E  F  G  H  I  J  K  L  M  N  O  P  Q  R  S  T  U  V  W  X  Y  Z



www.DataSheet.in    |   2017   |  संपर्क   |   खोज     |   English