DataSheet.in

TDA8003TS डेटा पत्रक PDF( Datasheet डाउनलोड )


डेटा पत्रक - I2C-bus SIM card interface - NXP

भाग संख्या TDA8003TS
समारोह I2C-bus SIM card interface
मैन्युफैक्चरर्स NXP 
लोगो NXP लोगो 
पूर्व दर्शन
1 Page
		
<?=TDA8003TS?> डेटा पत्रक पीडीएफ

TDA8003TS pdf
Philips Semiconductors
I2C-bus SIM card interface
Product specification
TDA8003TS
FEATURES
Subscriber Identification Module (SIM) card interface in
accordance with GSM11.11, GSM11.12 (Global System
for Mobile communication) and ISO 7816 requirements
VCC regulation (3 or 5 V ±8%) with controlled rise and
fall times
Card take-off protection
One protected and buffered pseudo-bidirectional I/O line
(I/O referenced to VCC and SIMI/O referenced to VDDI)
Clock generation (up to 10 MHz) with synchronous start
and frequency doubling
Clock stop LOW, clock stop HIGH or 1.25 MHz (from
internal oscillator) for cards Power-down mode
Automatic activation and deactivation sequences of an
independent sequencer
Automatic processing of pin RST with count of the CLK
cycles for start of the Answer To Reset (ATR)
Warm reset command
Supply voltage supervisor for Power-on reset, spike
killing and emergency deactivation in case of supply
drop-out
DC-to-DC converter (doubler, tripler or follower)
allowing operation in a 3 or 5 V environment
(2.5 VDD 6 V)
Enhanced Electrostatic Discharge (ESD) protections on
card side (6 kV minimum)
Power-down mode with several active features and
current reduction
Off mode with 2 µA current
Control from a microcontroller via a 400 kHz slave
I2C-bus (4 possible addresses: 48H, 4AH, 4CH
and 4EH)
Four parallel devices possible due to 2 sub-address
wires
Interface signals supplied by an independent voltage
(1.5 VDDI 6 V).
APPLICATIONS
GSM mobile phones
SAM interfaces in banking terminals
Portable card readers, etc.
GENERAL DESCRIPTION
The TDA8003TS is a low cost one chip SIM interface, in
accordance with GSM11.11, GSM11.12 and EMV96
(Europay, Mastercard, Visa) with card current limitation.
Controlled by I2C-bus, it is optimized in terms of board
space, external components count and connection count
(see Chapter “Application information”).
The integrated DC-to-DC converter ensures full
cross-compatibility between 3 or 5 V cards and 3 or 5 V
environments. The very low-power consumption in
Power-down mode and Off mode saves battery power.
ORDERING INFORMATION
TYPE
NUMBER
TDA8003TS/C1
TDA8003TS/C2
NAME
SSOP24
SSOP24
PACKAGE
DESCRIPTION
plastic shrink small outline package; 24 leads; body width 5.3 mm
plastic shrink small outline package; 24 leads; body width 5.3 mm
VERSION
SOT340-1
SOT340-1
2000 Apr 20
2

विन्यास 24 पेज
डाउनलोड[ TDA8003TS Datasheet.PDF ]


शेयर लिंक


अनुशंसा डेटापत्रक

भाग संख्याविवरणविनिर्माण
TDA8003TSI2C-bus SIM card interfaceNXP
NXP


भाग संख्याविवरणविनिर्माण
30L120CTSchottky RectifierPFC Device
PFC Device
AT28C010-12DKSpace 1-MBit (128K x 8) Paged Parallel EEPROMATMEL
ATMEL
B20NM50FDN-CHANNEL POWER MOSFETSTMicroelectronics
STMicroelectronics
D8442SD844SavantIC
SavantIC
FAE391-A20AM/FM Automotive Electronic TunerMitsumi
Mitsumi


Index : 0  1  2  3  4  5  6  7  8  9  A  B  C  D  E  F  G  H  I  J  K  L  M  N  O  P  Q  R  S  T  U  V  W  X  Y  Z



www.DataSheet.in    |   2017   |  संपर्क   |   खोज     |   English